Taiss40PCS Potentiometer Kit with Rotary knobs,WH148 B1K 2K 5K 10K 20K 50K 100K 250K 500K 1M Ohm potentiometers Assortment Single Linear Taper Rotary Audio B Type and Nuts,Washers

OK

I've been working on a small project and needed a couple small potentiometers. I just decided to order this whole set for a few extra dollars which included some knobs. Everything checked out including all the nuts and washers. I can't speak for the overall quality in the long run, but the values measured within specifications when I tested all of them.

price was right. about what you would expect for cheap electronics. gets the job done. the knobs look cool, but they are extremely thin wall. I could probably crush them flat between my fingers. probably better off with plastic.

I always like to have these potentiometers on hand so when one of my devices needs a replacement, (ie: radios, guitars, karaoke machines or testing equipment). There is a nice selection of potentiometer s here with a lot of different ohm values. This is a bargain. The knobs are very nice looking and are very good quality.

Calidad buen precio y variedad, llego y lo instalé inmediatamente funciona correctamente

Mine didn't come with enough washers for every pot. The nuts are hit or miss if they thread on. I have one that is so loose it slips over the mating thread like a washer would. The knobs I got also do not math the description. They're cheap and I got enough to feel it was worth the cost. It would just be nice if it was all there and as described.

This seems to have a useful (to me) selection of sizes. I did have a range in mind before purchasing. So far they’ve been sturdy and none have broken.The case is a bit overloaded. After removing a few knobs the dividers fell down and it was obvious I’d never put the knobs back in again and close the case. That’s okay for me because I have a storage drawer system - so I poured the knobs into it and use the case exclusively for the pots. I find the case useful for storing on a shelf. When I need one I put the case on my bench and get to work.Everything is neatly labeled. It seems like a good value.

Got a Traynor amp where 11 out 12 pots were sheared off where pins meet the phenolic. A mixture of values and tapers. This kit had most of them, got the others from Mouser. They all look and work pretty much alike. Good to have for future repairs.