Digital Temperature Sensor Breakout Moudle Board TMP102 (Pack of 2pcs)

Sensor fails a lot. Temperature readings do not match other sensors. Will cause errors, script stoppages, if touched or a strong draft is present.Came in two pack with one defective.

The pull-up resistors are all 1k ohm. It is too small for normal I2C drivers. They should be 4.7k or 10k. For some reason, I cannot get Alert output pin to work?

A little disappointed with this product. One of the two sensors is faulty/dead. It doesn't read any temperature when connected to Arduino. It perpetually outputs "-0.06".However, when I replace that faulty sensor with the second one (using the same code and wiring), that second one works like a charm. Unfortunately I needed both to work for my project.